Specification
| FRP Proportioner | |
| Maximum air inlet pressure |
7 bar, 0.7 MPa
|
| Maximum air inlet pressure to ASME solvent pressure pots |
7 bar, 0.7 MPa
|
| Typical flow rate of pattern guns |
Refer to RS Gun manual.
|
| A component (catalyst) inlet size |
3/8 in tube
|
| B component (resin) inlet size |
1 5/16-12 UN-2A male
|
| Wetted parts |
Stainless steel, carbide, UHMWPE, PTFE, and acetal
|
| Resin Wetted Parts |
Stainless steel, tungsten carbide with 6% nickel, UHMWPE, PTFE, (LW100C displacement pump only: Also includes carbon steel)
|
| Catalyst Wetted Parts (Series A and B systems, built prior to April 2013, have non-metallic nylon catalyst tube fittings. To convert your system to stainless steel fittings, see the FRP Proportioner manual) |
301, 303, 304, 316, and 17-4 PH grades of stainless steel, silicon nitride, acetal, perfluoroelastomer, PE, PTFE, UHWMPE, polypropylene
|
| Maximum fluid working pressure | |
| 13:1 Systems: |
9 MPa, 90 bar
|
| 17:1 Systems: |
11.9 MPa, 119 bar
|
| Maximum fluid temperature (Maximum fluid temperature rating determined by lowest rated component in system) | |
| Models with RS Gun |
38°C
|
| Models without RS Gun |
71°C
|
